一、Overview: This product is suitable for industrial and mining enterprises and urban water supply treatment equipment that require filtered water turbidity generally within 5 mg/L to meet drinking water quality standards for industrial or domestic water. It has a good removal effect on suspended solids in industrial sewage. The suspended solids in the water are agglomerated flakes and the adhesive colloidal particles that cannot be removed by sedimentation can pass the water through the filter layer installed in the pressure filter to make the water transparent.

There are two options for this product:

The single-layer filter material filter is suitable for raw water whose incoming water turbidity is often around 100 mg/L and has not been coagulated and precipitated (for example, when raw water with higher turbidity is often used, attention should be paid to the shortening of the operating cycle or the reduction of the filtration rate ), this type of filter should be filled with coagulant in front when using it.

Double-layer filter material filtration is suitable for precipitated water whose incoming water turbidity is generally below 15 mg/L, with a maximum of no more than 20 mg/L.

二、Main technical description: working pressure 5kgf/cm2

Inlet water temperature ≥4℃

Running speed 10m/min

Turbidity: Inlet water＜20 mg/L Outlet water＜5 mg/L

Compressed air is required for φ2400 and above to assist flushing during recoil.